Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
7 OPERATION
NOTE: Read and understand all warning and caution notices contained in this manual before using the meter.
Set the function selector to the "OFF" position when the meter is not in use.
7.1 AC/DC Current Measurements
WARNING: Ensure that the test leads are disconnected from the meter before making current measurements
with the clamp.
-
Set the function switch to the AC/DC Current. If the approx. range of the measurement is not known, se-
lect the highest range then move to the lower ranges if necessary.
-
Press the REL button to zero the meter display.
-
Press the trigger to open the jaw. Fully enclose only one conductor. For optimum results, centre the con-
ductor in the jaw.
-
The clamp meter LCD will display the Reading.
7.2 AC/DC Voltage Measurements
-
Insert the black test lead into the negative COM terminal and the red test lead into the
-
Set the function switch to the AC/DC position.
-
Connect the test leads in parallel to the circuit under test.
-
Read the voltage measurement on the LCD display.
7.3 Resistance Measurements
-
Insert the black test lead into the negative COM terminal and the red test lead into the
-
Set the function switch to the
-
Use the MODE button to select Resistance Measurements.
-
Touch the test probe tips across the circuit r component under test.
-
Read the resistance on the LCD display.
7.4 Capacitance Measurements
WARNING: to avoid electric shock, discharge the capacitor under test before measuring.
-
Set the function switch to the
-
Insert the black test lead banana plug into the negative COM Jack and the red test lead banana plug into
the
-
Use the MODE button to select CAP Measurements.
-
Touch the test probe tips across the part under test.
-
Read the capacitors value in the display.
-
The display will indicate the proper decimal point and value.
.
.
position.
position.
positive jack.
KPA-11T
TRMS CLAMP METER
31 / 46
Publicité
Table des Matières
