Start Up Instructions; List Of Materials; Mounting The Machine; Mounting The Bar And Chain - Garland BULK 316 E Manuel D'instructions

6. START UP INSTRUCTIONS

6.1. LIST OF MATERIALS

This machine includes the following elements that you
will find inside the box:
• Engine.
• Bar chain.
• Chain.
• Bar cover.
• Instruction manual.

6.2. MOUNTING THE MACHINE

6.2.1. MOUNTING THE BAR AND CHAIN

This machine has quick and easy chain tensioning
manual system and without the use of tools.
The chain of the machine has very sharp teeth.
Always use security gloves to avoid accidental cuts.
Make sure the machine is not connected to the
mains before doing any maintenance or other work
on the machine. The bar and chain are supplied
separately. To mount them, follow the following steps:
1. Activate the chain brake pushing forward until you
hear a click sound.
2. Loosen the Blocking nut of the bar and
remove the chain cover.
3. Place the chain on the bar.
Before mounting the chain on the bar, make sure
the direction of the chains teeth are facing correctly.
The correct position of the chain will have the cutting
edges facing clockwise.
4. Mount the bar (with chain installed) by placing the
chain around the drive sprocket and matching the
hole with the bolt.
5. Install the cover making sure that the
locking nut (1) is fixed in the screw
hole. Lightly tighten the locking nut (1) on the bar.
6. Turn the tension wheel (2) clockwise to tighten
the chain until the chain tension is correct (See pt.
6.3.4.Tensioning the chain).
7. Hands tighten the blocking nut, strongly (1).
8. Check that the chain slides along the bar
1
maimtaining at all times the tension when you
37/152
English
2
1