Mounting The Handle; Connecting To The Mains - Rothenberger Industrial ROTURBO 12000 Mode D'emploi

INSTALLATION / PREPARING FOR USE

MOUNTING THE HANDLE

Mount the handle onto the gas heater using the screws provided. Use a PH2 phillips
screwdriver.
CONNECTING TO A GAS CYLINDER
CAUTION. The appliance may only be used with the hose and regulator supplied.
- Ensure that all valves are closed.
- Check that the seal between the regulator and the gas container are in place and in good
condition before connecting to the gas container. Depending on the version / country, the
seal may be located in the pressure regulator connection, in the gas cylinder connection
or in both connections. In case of doubt, please contact your local gas dealer.
- Check the condition of the hose and regulator each time before using the burner. Do not
use a hose or regulator that is damaged or worn.
- Connect the pressure regulator to the gas cylinder. Ensure that the direction of rotation of
the thread is correct (there may be differences according to country).
- Install the hose failure safety device, if available.
- Connect the gas hose to the pressure regulator and to the appliance. The hose end
connector and the appliance connector have left-handed threads.
- Tighten the connections and the pressure regulator with a suitably sized open-ended wrench
(there may be differences according to version / country). Do not exert excessive force to
prevent over-tightening or damaging the threads.
- Open the cylinder valve. Ensure that all the connections are tight. Use a leakage detection
spray or soapy water for this purpose. The connections may have to be re-tightened.
- Do not use the device if there is a leak in the system.
- Close the cylinder valve after performing the leakage test.

CONNECTING TO THE MAINS

- Ensure that the rated power indicated on the machine label corresponds with your mains
before using the machine.
- Connect the appliance to a correctly earthed socket.
All manuals and user guides at all-guides.com
13