Configuring The Settings - SoftBank pepper Guide Rapide

C.

Configuring the settings

Pepper does not need to be standing on the Charging Station
during the configuration.
This procedure is designed for NAOqi 2.5.2. It may not
apply to your Pepper. For other versions, check the online
documentation. Open the Settings page to check your NAOqi
version.
1.
Open the Settings page
a.
When Pepper is idle, press the Tablet once to display the
App Launcher.
b.
Press the Settings icon
The Settings page appears.
2.
Press the Charging Station settings button
If the button is not displayed, you can either:
• Update Pepper's software in the Applications update
menu
Or
• Download the Auto recharge App in the App store.
3.
Press the grey switch to allow Pepper to
automatically use the Charging Station when its
Battery is low
The switch turns green and optional settings appear. To
configure them, see part D. Configuring optional settings.
If you do not configure optional settings, Pepper uses the
Charging Station only when its Battery level is low, and
leaves it when its Battery reaches 100%.
4.
Leave the Settings page
a.
Press the exit button
A confirmation window appears.
b.
To leave the Setting page and save your modifications,
press Exit. To stay on the Settings page, press Cancel.
.
in the top right of the screen.
D.
Configuring optional settings
1.
Go to the Charging Station settings page.
2.
To set the Battery percentage at which Pepper
leaves its Charging Station, use the + and - buttons
Default setting is 100%.
3.
Set Charging Hours
a.
Press the grey switch at the bottom of the page to activate
Charging Hours.
The switch turns green.
b.
Press Edit.
c.
Press the drop-down menus to select Charging Hours as
follows: "From (start hour) (start minute) to (end hour)
(end minute)".
d.
To save the Charging Hours you selected, press Apply. To
quit the selection of Charging Hours without saving your
modifications, press Cancel.
E.
Checking the first use
It is recommended to watch over this manoeuvre the first time
to ensure it is carried out successfully. The whole procedure
lasts a few minutes.
Commands are given vocally. Make sure Pepper identifies you
and listens to you before talking (see Beginner's Guide).
1.
Say to Pepper: "Go to your Charging Station"
• Pepper looks around for the Charging Station.
It searches an area of 3 meters (around 10 ft) and 180° in
front of it. If it doesn't find the Charging Station, it turns
90°, and checks again until it completes a full turn on itself.
• Pepper sees the Charging Station and positions itself
right in front of it.
• Pepper aligns with the Charging Station, then turns
around.
Pepper may be loud when it aligns with the Charging
Station.
• Pepper rolls back onto the Charging
Station.
• When Pepper is connected, the LEDs of
the Charging Station turn OFF.
You can interact with Pepper when it is
on the Charging Station but it can't move
its wheels.
The Battery charger LED indicates the
charging status. Please refer to the
Pocket Guide for further information.
2.
Say to Pepper:
"Leave your Charging Station"
Pepper leaves the
Station and stops in front of it.
3.
When Pepper docks, check if the Charging Station
moves
If the Charging Station has moved, please refer to Securing
the Charging Station and follow the instructions.
Charging
3