User Program; Other Information - FOCUS FITNESS FOX 3 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
Fox
Programs:
1. Manual
In the manual program, you can enter your own training data, namely maximum time,
distance or calories. With this, the training will be based on your own settings. You
can also press START directly to start the workout without data. After this, the
resistance with the UP / DOWN keys (ROTARY KNOB) can be increased or
decreased.
Program
2.
By means of the UP / DOWN (ROTARY KNOB) keys you can choose between the
various pre-programmed programs, with MODE / ENTER you can select the program
and you can install a desired time or distance. You can also immediately press
START to start the workout without a set time or distance.

3. User program

By means of the UP / DOWN (ROTARY KNOB) keys you can install a resistance,
with the MODE / ENTER key you confirm the resistance and you will proceed to the
next column in order to program an entire training yourself. By pressing the MODE
key for 2 seconds, the installation will stop.
4. Watt
By default, a wattage is shown, when it blinks you can increase or decrease it with
the UP / DOWN buttons (ROTARY KNOB). Press MODE / ENTER to confirm the
selection.
5. H.R.C.
Before the training, you will be asked about your age (AGE) and then calculate a
target (TARGET) heartbeat. With the UP / DOWN keys (ROTARY KNOB) you can
change the desired heart beat target to 55% (weight loss), 75% (fitness), 90%
(intensive) and TARGET (personal interpretation).
6. Recovery
When you are at the end of the training, you can test your fitness with the
RECOVERY button (for this you have to hold the heart beat sensors on the steering
wheel). All data will stop and the time will count down from 00:60 to 00:00. After this,
a code will be shown, F1 (very good), F2 (good), F3 (average), F4 (sufficient), F5
(bad) and F6 (very bad).

Other information:

-
Use the standard supplied adapter.
-
If the device is not used for a few minutes, the sleep mode will be activated.
-
In case of a defect, the plug must be pulled out and inserted again.
Manual – Elliptical – Focus Fitness – Fox 3 – FFCR015
3
13

Publicité

Table des Matières
loading

Table des Matières