Maintenance & Care - Bissell VAC & STEAM 1132 Mode D'emploi

Operations
Using Your Vac & Steam Hard Floor
Vacuum and Steam Mop
The hard floor cleaner can be used as a stick
vacuum and a steam mop at the same time or
separately. For best results, use the powerful
vacuum to clear floor of dust and small debris as
you steam mop.
Your hard floor cleaner is designed to clean hard
flooring, such as ceramic tile, vinyl, marble, stone
and sealed hard wood floors. Use on waxed or
some unwaxed floors may result in a diminished
glossiness. The hard floor cleaner is not for use on
unsealed wood floors. For best results, test in
an inconspicuous area and check the care instruc-
tions from your flooring manufacturer.
1. Plug the unit in and wait 30 seconds for it to
heat up. When the Steam Ready light illuminates,
choose the level of steam to clean your floor:
HI (for durable floors or sticky messes) or
LO (for delicate floors or every day cleaning).
2. Press steam trigger on the underside of the
handle to actuate steam
3. Push the VAC switch down to turn on the
cyclonic vacuum.
4. Begin cleaning by slowly passing the unit over
the floor surface while pressing the steam trigger
on the underside of the handle.
5. When the hard floor cleaner stops emitting
steam, turn the unit off (both steam mop and
vacuum functions) and unplug. Open the Easy Fill
opening of the water tank and use the water cup
to add more water to the tank. For best results,
water should be at room temperature. Then close
the Easy Fill opening, turn the unit back on and
continue cleaning. To be sure to sanitize an area
of your floor, use the microfiber cloth pads and
slowly and evenly strike the Symphony back and
forth at least three times over the area using con-
tinuous steam. For best results, remove the pad
and wash after use.
Maintenance & Care
Removing Mop Pad
1. Unplug hard floor cleaner from electrical outlet.
2. Step on foot release for mop pad tray to
lift unit off tray.
3. Carefully remove mop pad from the mop
pad tray using the Quick Release™ Tab. The
mop pad and tray may be hot.
4. Put the mop pad tray back down on the
floor and set the unit back on top. It will click
into place.
5. Mop pad can be machine washed in warm
water. Use only liquid detergents. Do not use fab-
ric softeners or bleach. For best results, air dry.
WARNING
Never put descaling, alcoholic, or detergent products
into the steam cleaner, as this may damage it or make
it unsafe for use.
1.
2.
WARNING
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
2.
Tip
» For vacuum use on low
pile area rugs, remove
pad tray for improved
performance.
7