Installing Batteries - ThermoPro TP-07S Manuel D'utilisation

LCD
Thermometer Mode
EN
Probe Temp Reading
Transmitter Features
Soft rubber
sleeve
Sensor
socket hole
TX indication led
ºF/ºC/
LCD (Liquid Crystal Display)
Wire Stand – Allows you to stand the transmitter on tabletop or it can be
reversed and used as a hanger.
Battery Compartment – holds 2 AAA batteries.
Sensor Socket Hole: plug in for stainless steel probe sensor.
Transmission frequency: 433 Mhz
Maximum transmit power: 8 mW
All manuals and user guides at all-guides.com
Timer Mode
Timer
Meat type
Taste level
Probe Temp
Setting
Wire Stand
Battery Compartment
-4-
Buttons
ºF/ºC/ – Press and hold for 2 seconds to turn the transmitter ON or OFF.
Press once to select temperature readings in Celsius or Fahrenheit.

Installing Batteries

Open the battery compartment of the receiver and insert two "AAA" batteries with
correct polarity. Open the battery compartment of the transmitter and insert two
"AAA" batteries with correct polarity.
Turn On/Off Unit
Press and hold F/ C º º / button on the receiver for 2 seconds to turn on/off the
receiver.
Press and hold ºF/ºC/ button on the transmitter for 2 seconds to turn on/off the
transmitter.
Synchronize/Pair Transmitter and Receiver
The transmitter and receiver were already paired at our manufacturing facility.
Usually you do NOT need to re-synchronize or re-pair the units. You just plug in the
probes, insert batteries, turn on the receiver and the transmitter and wait for a few
seconds, you will see the temperatures shown on both receiver and transmitter
and the units are ready for use.
However, in some unusual cases, the transmitter and receiver are no longer paired,
then you may need to re-synchronize them by following the below steps:
a. Insert the stainless steel probes into the corresponding ports in the transmitter.
b. Turn on the transmitter by pressing and holding the ºF/ºC
seconds. The transmitter will show the current temperatures on its LCD display.
c. Turn on the receiver by pressing and holding the F/ C
d. Press and hold Mode button on receiver for 2 seconds to enter the synchroniza-
tion mode which will last for 60 seconds. The display shows "---" and it is flashing.
e. Wait for a moment until the temperature reading shows on the receiver display,
it means the synchronization/Pairing is complete. Your professional remote
/ button for 2
º º / button for 2 seconds.
-5-
EN