Brandt BFV10G Manuel D'instruction page 24

Your soleplate gives off
particles.
The jet does not work.
Steam or water is released
from the iron when you
finish filling the tank.
Water runs from the holes in
the soleplate.
The appliance does not contain any parts that can be repaired by the user. Do not attempt to
repair the appliance yourself. The appliance must be repaired by a professional.
If the power cord is damaged, it must be replaced by the manufacturer, a representative of the
service centre or a qualified person.
soleplate with steel wool or
abrasive wool.
Limescale is starting to build
up on your soleplate.
There is not enough water in
the water tank.
The steam control is not set
to the position .
The selected temperature is
too low and does not allow
steam to form.
You are using the steam
function when the iron is not
hot enough.
You are using the steam jet
button too frequently.
There is too much steam.
You have stored the iron
horizontally without
emptying it and without
setting it to .
23
Clean the steam iron.
Refill the water tank.
Check that the steam control
is set to the position
Do not overfill the water
tank.
Position the thermostat in
the steam range (from ... to
MAX).
Wait for the thermostat LED
to switch off.
Wait a few seconds between
button pushes.
Reduce the steam.
See the section "Storing the
iron".
.