Water Spray Function; Anti-Drip System; Safe Stop Function; Tissu Protect Function - Brandt BFV10G Manuel D'instruction

d) Water spray function
This function can be used to iron out the most stubborn creases.
1. Check that the tank has enough water.
2. To humidify the ironed fabric, press the spray button several times. Water will come
out of the spray nozzle at the front of the iron.
e)

Anti-drip system

Your iron is fitted with an anti-drip system which allows you to iron without leaving water
marks on the clothing.
f)

SAFE STOP function

For maximum safety, the iron automatically switches itself to standby after 4 minutes when it
is positioned on its heel.
The LED will flash to let you know that the iron is no longer heating.
When you pick the iron up again, the LED switches off and the standby function is removed.
g) TISSU PROTECT function
To protect your clothes, the iron automatically switches itself to standby after 20 seconds
when it is left horizontally on your clothes without movement.
The LED will flash to let you know that the iron is no longer heating.
When you pick the iron up again, the LED switches off and the standby function is removed.
Recommendations for use:
- Start by ironing fabrics requiring low temperatures, then continue with those requiring
a higher temperature.
- Be careful not to iron zips or press-stud fastenings as they might scratch the coating
on the iron's soleplate.
- It is normal for the LED to switch on and off again while ironing.
- For delicate fabrics, we recommend that you test the fabric on the inside first.
- If you do not know the composition of an item, determine the correct temperature by
ironing a part that is not visible when the item is worn or used.
21