CLAS HU 0639N Mode D'emploi page 8

HU 0639N
• Before connecting the air coupling to the nipple, check your air compressor.
• Then connect the air coupling to the air inlet end cap as shown in the adjacent
• The pump will then start until the hose is completely fi lled with oil.
• The pump is then ready for use and you only have to pull the trigger to start
• When the pump is not in use, remove the air connection.
• Push the trigger of the gun and remove the air from the pump.
• If there is any air left in the pump, it could be damaged and its service life shortened.
• The device must be operated by qualifi ed and fully equipped personnel.
• Possession of a compressor is mandatory. It must provide a fl ow rate between 6 and 8 bar and be
compatible for continuous operation.
• The oil level in the drum must be constantly checked by the operator. Never use the pump if there
is no more oil in the drum.
• Make sure that no dirt accumulation due to the lubrication process remains in the pump.
• Pay attention to changes in oil viscosity (e. g. barrel temperature change, etc.)
CAUTION!
• CLAS cannot be held responsible for the failure of attempts to implement the instructions described
above.
• Any damage resulting from non-compliance with the above instructions will not be covered by the
warranty.
3:1 PNEUMATIC OIL PUMP+FLEXIBLE BARRELS 180-220kg
USE
The pressure must be between 6 and 8 Bar maximum.
image.
working.
• It is recommended to use a pressure regulator.
It allows the incoming air to be controlled
and above all to fi lter the water that could be
contained in the air.
• If you do not use a pressure regulator, lubricate
the pump daily with oil (grade 10) through the
air inlet nozzle.
• Water that could be inserted with air could
cause damage to the pump components.