Kolpin 2901 Instructions D'installation

Please read and understand these instructions completely before installation to avoid injury to yourself, damage to the vehicle or accessory.
Be certain to follow all specifications. For proper installation, two people are required
Dealer: These instructions contain important information for future reference and must be given to the customer at time of purchase or
upon completion of installation. Torque specifications must be followed when tightening bolts.
ITEM PART NAME
A Windshield
B Edge guard strip
C 1 ¾" diameter Clamp set
D Pivot components with nuts & bolts
1. Installation
a) To apply the edge guard (Item B) to the windshield (Item A), find a clean flat area
where you can lay down the windshield. With extreme caution, partially remove
the protective film and apply the edge guard using manual pressure to ensure good
adhesion to the windshield.
b) Attach pivot components (Item D) to the windshield with supplied hardware as
follows. All screws that are passing through the windshield will be tightened
later in step d).
c) Attach clamps (Item C) to the roll cage of your vehicle as per drawings. Attention; all clamps are not installed the same way. Do
not tighten at this stage; you will need to make adjustments later on.
2901 - Installation instructions JOHN DEERE XUV620i/850D/HPX Short Windshield revision 00
INSTALLATION INSTRUCTIONS
JOHN DEERE XUV620i/850D/HPX SHORT WINDSHIELD
PART # 2901
Parts List
(parts available with kit only and not available separately)
CNC windshield cut-out made of ¼" thick GE MR10 polycarbonate
Includes : 1 x 36" edge guard strip [end user to cut to exact length]
Includes : 2 upper pivots, 4 upper pivot cylinder adaptors, 4 button head screws M6 x
45, 2 angle adaptor (10 deg.), 8 button head screws M6 x 18, 4 internal lock washers
M6, 4 plastic shoulder washers M6, 4 socket cap screws M6 x 20, 4 locknuts M6 and
Button head screw M6 x 18
Button head screw
M6 x 45
Top pivot
cylinder adaptor
Button head
screw
M6 x 18
DESCRIPTION
Includes : 2 male clamp parts, 2 female clamp parts
2 knobs M6 x 16
Edge guard strip
Internal lock
washer M6
Shoulder
washer M6
Locknut M6
Female
clamp part
Windshield
Upper
pivot
Windshield
Male clamp
part
WWW.KOLPIN.COM
QTY
1
1
2
1
Angle
adaptor
(10 deg.)
Socket cap
screw
M6 x 20
1