Stanley FatMax FMFP12703 Manuel D'instructions Et D'entretien page 6

SEQUENTIAL ACTION TRIGGER (GREY)
• When using the sequential action trigger, do not actuate the tool
unless the tool is placed firmly against the workpiece.
• DEPTH ADJUSTMENT: To reduce risk of serious injury from accidental
actuation when attempting to adjust depth, ALWAYS:
• Disconnect air supply.
• Avoid contact with trigger during adjustments.
• Do not drive nails blindly into walls, floors or other work areas.
Fasteners driven into live electrical wires, plumbing, or other types of
obstructions can result in injury. (Fig. U)
• Stay alert, watch what you are doing and use common sense when
operating a power tool. Do not use tool while tired or under the
influence of drugs or alcohol. A moment of inattention while operating
power tools may result in serious personal injury.
Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities contains chemicals known to the State of California to
cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• lead from lead-based paints
• crystalline silica from bricks and cement and other masonry products
• arsenic and chromium from chemically-treated lumber
Your risk from these exposures varies, depending on how often you do this type
of work. To reduce your exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such as those dust masks that
are specially designed to filter out microscopic particles.
Use of this tool can generate and/or disburse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles
away from face and body. Always operate tool in well-ventilated area and provide
for proper dust removal. Use dust collection system wherever possible.
ALWAYS USE SAFETY GLASSES. Everyday eyeglasses are NOT
safety glasses. Also use face or dust mask if operation is dusty. ALWAYS WEAR
CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA respiratory protection.
Before operating this tool, carefully read and understand all instructions
in Important Safety Instructions.
Nails
Lengths
Angle
Air Inlet
NAIL SPECIFICATIONS
FMFP12703
0.113" – 0.131" (2.87–3.33 mm) diameter,
papertape collated clipped head framing nails
2"–3-1/2" (50–90 mm)
1/4" NPT (6.4 mm)
6 - ENG
34º