Cold Weather Operation - Stanley FatMax FMFP12703 Manuel D'instructions Et D'entretien

Fig. 12
5. If nail still can not be removed,
remove the magazine:
a. Remove screws (N).
b. Remove magazine.
c. Remove bent nail.
d. Reassemble in reverse order.
6. Verify function.
NOTE: Should nails continue to jam
frequently in nosepiece, have tool
serviced by an authorized Stanley Black
and Decker service center.

COLD WEATHER OPERATION

When operating tools at temperatures below freezing:
1. Make sure compressor tanks have been properly drained prior to use.
2. Keep tool as warm as possible prior to use.
3. Make certain all fasteners have been removed from magazine.
4. Put 5 to 7 drops of non-detergent SAE 20 weight pneumatic tool oil in the air
inlet.
5. Lower air pressure to 80 psi (5.5 bar) or less.
6. Reconnect air and load nails into magazine.
7. Actuate the tool 5 or 6 times into scrap lumber to lubricate O-rings.
8. Turn pressure up to operating level (not to exceed 120 psi) and use tool as
normal.
9. Re-lubricate at least once daily.
10. Always drain the compressor tanks daily or after each use.
HOT WEATHER OPERATION
Tool should operate normally. However, keep tool out of direct sunlight as
excessive heat can deteriorate bumpers, O-rings and other rubber parts resulting
in increased maintenance.
Fig. 13
N
12 - ENG
N