MaxLite WallMaxx WP-OP Serie Mode D'emploi page 2

Operating Instructions
MaxLite WallMax™ Open Face
®
Note: Add a bead of exterior grade silicone sealant around the perimeter of the wall pack on the wall to inhibit any moisture
Installation & Operation - Junction Box Mounting:
from attachment bolts.
1. Unscrew the screws on the right side using a
suitable screwdriver. Separate the male and
female connectors, then remove the reflector
from the back plate.
Reflector
Male
Connector
3. Run the main power wire from the water-proof
J-box through the hole(H), then lock the back
plate to the water-proof J-box using four
#8-32 screws.
#8-32 Screws Main Power
Installation & Operation - Conduit Mounting:
1. Unscrew the screws on the right side using a
suitable screwdriver. Separate the male and
female connectors, then remove the reflector
from the back plate.
3. Run the main power through the right hole and
then finish the wiring (Black wire - L, White wire -
N, Green wire - G) See wiring diagram on page 2.
Screw
Components
Note: If the Wall pack has an internal emergency driver, use the 2nd installation instructions - Conduct Mounting.
F
© Copyright 2020. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
Female
Connector
Hole(H)
Water-proof J-Box
E
Bolt (5)
G
2. Create four 5.0mm holes by knocking-out the four points indicated
in A/B/C/D. Unscrew Bolt(1) from the bottom center. (Note: the
other three Bolts (2)/(3)/(4) can be unscrewed depending on
your requirements during the wiring process.)
Bolt (4)
A
B
Electric
Drill
Back Plate
4. Use the hinge to lock the reflector to the back plate firmly, then
connect the main power. Black wiring to L, White to N, Green
to G (see diagram above.) Next, connect the male and female
connectors together. Finally, use a suitable screwdriver to
connect the reflector to the back plate.
Reflector
Male
Connector
2. Unscrew the right-side Bolt(5). Drill three 6.5mm holes in E/F/G
using a suitable drill. Next, fasten the back plate to the wall with
the three screw components. (Make sure to waterproof three open
holes-E/F/G.)
4. Use the hinge to lock the reflector to the back plate firmly. Next,
connect the male and female connectors together. Finally, use a
suitable screwdriver to connect the reflector to the back plate.
Reflector
Male
Connector
Bolt (3)
Bolt (2)
D
Bolt (1)
C
Back Plate
Female
Connector
Main Power
Back Plate
Female
Connector
WP-OP Series
Page: 2
REV: 01/14/20