Publicité
Les langues disponibles
Les langues disponibles
Always wear SAFETY GLASSES
`
when installing hitch
Existing
M14 Bolt
Scan for step by step
PHOTO installation
Existing
instruction or visit
M14 Bolt
http://www.cequentgro
up.com/qr-product.aspx
1.
Remove existing M14 bolts from attachment holes, 1 at the end of the frame rail and one on the outside of the frame rail forward of the exhaust hanger. Keep for re-installation.
2.
Scrape frame rails to remove any caulk near the attachment holes.
3.
Raise hitch into position and re-install the M14 fasteners removed in the previous step.
4.
Tighten all M14 fasteners with torque wrench to 115Lb.-Ft. (156N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2015 Cequent™ Performance Products, Inc. -
Installation Instructions
PART NUMBERS: 36587, 90247, 06947
This page is for vehicles with existing
Rear
Figure 1
Printed in Mexico
towhooks
Sheet 6 of 21
Frame rail
Existing
M14 Bolt
Existing
M14 Bolt
36587NP
10-9-15
Rev. B
Publicité
