Cequent Performance Products 36587 Instructions D'installation page 5

5. Raise hitch into position, guiding the fishwire ends thru the attachment hole on the hitch.
Once the hitch is in place remove the fishwire and install the conical washer (teeth side against
hitch) and nut. Hand tighten only at this time.
7. Tighten all 1/2" fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
6. Fishwire the second carriage bolt and spacer thru the access hole and thru the attachment
hole in the frame rail and hitch, install the conical washer (teeth side against hitch) and nut.
*Example of fishwire technique
8. Re-install the 10mm nut for the plastic inner fender and the access door removed earlier.
Sheet 5 of 21 36587NP 10-9-15 Rev. B