habitat et jardin 1536 128813 Mode D'emploi page 5

SAVE THESE INSTRUCTIONS
Introduction
This robust and weatherproof heater is designed for domestic and commercial heating applications at
outdoor well-protected areas.
Model
Voltage(V)
Wattage(W)
Hertz(Hz)
Dimensions W×H×D(mm)
Weight(KG)
INSTALLATION
Tools Needed:
* Pencil *Hammer *Level
A wall mounting bracket is provide with the heater which has been specifically designed to allow this
product to be fitted to a ceiling before drilling the holders for the ceiling is solid and that there are no
hidden water pipes or electric wires. The heater must be installed no less than 19.7"from side walls and no
less than 2.4m off the floor.
ATTENTION! The appliance must be installed on the solid surfaces like concrete, wood, or metal etc.
Important: Ensure that the supply cables are well mounted and that it does not meet reflector of the heater
or that does not trail into heated area, the supply cable can be fixed to the metal mounting bracket behind
heater with plastic zip ties.
1. This heater should be installed by a competent person, i.e., a qualified electrician.
2. Always disconnected the heater from the electricity supply and allow it to cool before installation.
3. For ceiling mounting, the lowest part of the heater must be located at or above a minimum height of
2.4m from ground level, so that the heater cannot be touched when in operation.
4. For ceiling mounting, there must be a 2.4m distance from your appliance to the ground.
5. When installed to the ceiling, there must be 0.5m between corners and the appliance.
6. The distance of your appliance from the living beings is to be min 1m.
7. The distance from the front side of the heater to materials such as wood, carton, cloth etc., must be min
1m.
8. When mounting to a ceiling, do not position the heater at an angle more than 90°and less than 45°.
9. The supply cable must be at the lower end of the heater if the heater is installed at an angle or vertically.
10. Keep the supply cord away from the body of the heater which will get hot during use.
11. Do not install the heater on an inflammable surface.
12. Observe the minimum safe distance between the heater body and the inflammable surfaces when
mounted.
13. The heater should always have a minimum clearance of 0.5m from a ceiling and adjacent wall.
14. If the heater is to be used outside, a weatherproof outlet is recommended.
15. Before drilling ensure that there are no wires or water pipes in the area where the heater is to be
installed.
16. The heater must be installed on the mounting brackets provided.
17. Fasten the brackets securely to the mounting surface and the backside of the heater using the nuts and
screws supplied.
18. Fasten the heater securely on the brackets using the nuts and bolts supplied.
19. The brackets can be used to adjust the direction of the heater, adjust the heater angle by loosening the
two bolts on the wall mounting bracket, tighten the bolts again when the desired angle is reach
*Screwdriver *Power Drill and drill bits
SUNDEAR XD-YS
220-240V AC
1500W/2000W
50/60
56*10.6*7.2cm
1.4KG