Publicité
Les langues disponibles
Les langues disponibles
2. Connect the red wire of control box to positive pole of reversing light,
black wire to the negative, red power wire of camera to the positive
pole of reversing light; (ref: installation diagram).
3. Connect video wire following the general installation diagram.
4. Put the car into reverse gear, the rear camera signal enters control box
and will be output via VOUT after superposing characters.Then there
should be a image with a white dot on the display, indicating parking
sensor entered normal detecting.
Test:
. If the display does not show any image, please check whether
A
the polarity of the power is correct, the cables are correctly
connected, the voltage is beyond regulated, or the plug on the
display is well connected.
. If the display is in disorder, please exit and put the car into
B
reverse gear again. If the problems still could not be solved, the
control box could be deemed defective which needs a entire
replacement.
6
5. If a person stand right before the sensors within 1m, he/she should be
detected normaly
Test:
. Insert one sensor into control box, if the horn gives continuous
A
sound and show "0.0", please check wheter it detected rear
outshoot (such as registration mark, spare wheel, bumper, etc.), the
sensor is fixed too tight or near to some strong interference
sources (such as exhaust pipe, other wires).
. If it shows distance figure on display without any obstruction
B
around the sensor, it may detect the ground, please check the
positon and direction of sensor;
. If the problem still can not be removed, the whole system should
C
be replaced.
Note:
A
.This display could be interchangeable, but the connection
between the sensor and control box or the joint end is unique.
.The display program: it displays "0.0" and gives continuous sound
B
when the system detects something in the distance range of
0.0~0.2m; the alarm will stop for 1 more second at the distance of
0.5m. Please pay attention to the above note while testing.
NOTE
1.The car must be in power-off during the installation.
2. It's performance may be affected in following situation: heavy rain, fravel
road, bumpy road, sloping road, and bush, very cold, hot or moist
weather, or the sensor is covered by ice, mud, etc.
3. Switches among ultrasonic and electric wave, DC and AC may effect its
performance.
4.The sensors should be installed appropriate loose or tight.
5. It's performance may be effected if the sensors are fixed on metallic
bumper.
6. Avoid installing the digital control box in places of great interference,
such as vent-pipe, wiring nearby.
7.Test the system to make sure it works normally before using
8.This system is a reversing aid and the manufacturer will make no
responsibility for any accident after the kit is installed.
GENERAL INSTALLATION DIAGRAM
Control box
Camera
Horn
Horn
This system excludes display, a display
should be outer connected in addition.
Control box
Reverse light
Camera
Sensor
7
Publicité
