Caliber PARK 500 Mode D'emploi page 2

B.To perform the best detecting angle, select the
position for A and D sensor with 8-13cm away
from the side, 11cm is recommended, and 20°
with the side.
SELECT DRILLING POSITION FOR SENSOR AND CAMERA B,C AND E
A.Measure the distance between sensor A and D,
get the result "L".
2
B.Mark sensor B, C and E for every 1/4 "L"
interval. (Camera E should be in the middle of
the bumper)
DRILLING
A.Firstly, use a small driller tip to locate.
B.Drill with the original driller. Ø21MM
DRILLER FOR SENSOR HOLES AND
Ø25MM DRILLER FOR CAMERA HOLE.
SENSOR AND CAMERA INSTALLATION
A.Insert the sensors and camera into the holes
one by one and tighten them, the sensor with
metal slice must be up and down fixed instead
of right and left.The camera must be fixed with
the triangle mark upward.
B.Hide the wires in good order according to
various cars.
THE DIRECTION OF CAMERA
The camera must be fixed with the triangle mark
upward.
Vertical installation position to the ground.
Sloping installation position to the ground.
OBJECTS HARD TO BE DETECTED
Smooth slope
Smooth round objects
Objects absorbing wave, e.g. cotton
CONTROL BOX INSTALLATION
Locate the control box in the boot, keep safe,
cool, dry and away from shake or interference.
3