Cequent Performance Products 24934 Instructions D'installation page 7

9. Use the plastic pry tool to release the cleats at the top of the fascia while
carefully pulling the fascia away from the vehicle. Repeat for each side.
11. Remove (6) 15mm flange nuts attaching the bumper to the vehicle, remove
the bumper and set aside.
©2015 Cequent™ Performance Products, Inc. -
Printed in Mexico
10. Once the fascia is free from the vehicle disconnect the electrical connectors
from the license plate lights inside the fascia and locate and twist free the
TPMS sensor from it's connector. Set the fascia aside.
12. Attach hitch to the vehicle so that the hitch will be sandwiched between the
frame and the bumper.
Sheet 7 of 24 24934NP 9-29-15 Rev. B