Cequent Performance Products 24934 Instructions D'installation page 5

1. Locate and remove (2) 8mm screws from the wheel well. Repeat for each
side.
3. Locate the plastic rivet on the bottom of the fascia behind the wheel, push
out the center of the rivet with the 3/16" punch and remove the rivet from the
fascia , wheel well liner and metal bracket. Repeat for each side.
©2015 Cequent™ Performance Products, Inc. -
Printed in Mexico
2. Remove the first (4) plastic expansion fasteners above the 8mm previously
removed, by pushing the center of the rivet through with the 3/32" punch, (be
careful not to lose the pins that are pushed out) remove the head of the fastener
and keep for reinstallation. Repeat for each side.
4. Pull away the wheel well lining material and tuck it behind the tire to gain
access to the side marker light connectors, squeeze and detach the connectors
from the light. Repeat for each side.
Sheet 5 of 24 24934NP 9-29-15 Rev. B