Urmet 1071/32 Mode D'emploi page 10

2.3 Temporary Comfort / Day / Night / Safe (or
Protection) setting to the next change of
program
As described above, press the button
panel (if this was enabled by the installer) until the
required reference temperature blinks: Comfort
Day , Night . Blinking will indicate that the timer
(2)
is active.
Then press the button again and keep it pressed
until the LED stops blinking and stays on steady.
The setting will remain active until the next change
of program.
(2)
In the particular case in which all LEDs are off after having
pressed the button several times (safe or protection), the timer
will not be activated and the setting will last to the next change of
program.
10
2. INSTALLATION
The temperature sensor requires reliable information
in order to ensure maximum comfort.
on the front
For this reason, it must be installed in the reference
room and in a position where it measures the real
,
temperature without being influenced by other fac-
tors, such as the heat generated by occasional
sources (e.g. irons, television sets or kitchen stoves)
and from sources of cold (e.g. outside walls).
For effective operation, the sensor must be installed
on an inside wall opposite to the heating elements.
Installation near shelving, niches, doors or windows
should be avoided. It is also advisable not to install
the device on outside walls subject to solar radiation
or cold air currents or on inside walls crossed by the
heating system or sanitary hot water.
Suitable for installation in 503, 504 or 506 boxes (it
occupies only one module).
DS1071-012