Solar BA6 Mode D'emploi page 7

corresponds as follows:
OK – Charging System OK
HI – Charging Voltage is High
LO – Charging Voltage is Low
10. Next, the tester can provide an assessment of the charging system under load.
11. Without pressing ENTER, turn on the following accessories: blower to high
(heat), high beam headlights, and rear defroster.
Note: Do not use cycling loads such as air conditioning or windshield wipers.
12. The tester will display the charging system voltage under loads and provide an
assessment of that reading. Assessment correspond as follows:
OK – Charging System OK
HI – Charging Voltage is High
LO – Charging Voltage is Low
13. Turn engine OFF and remove the test leads from the battery posts after
completion of testing, always removing the negative clamp first and then the
positive clamp.