Regulatory Compliance - Clarity XLC7BT Mode D'emploi

Masquer les pouces Voir aussi pour XLC7BT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

REGULATORY COMPLIANCE

XLC7BT
h) Connection to party line service is subject to state tariffs. Contact the state
public utility commission, public service commission or corporation commission
for information.
i) If your home has specially wired alarm equipment connected to the telephone
line, ensure the installation of this telephone equipment does not disable
your alarm equipment. If you have questions about what will disable alarm
equipment, consult your telephone company or a qualified installer.
j) This telephone equipment is hearing aid compatible.
Customer-Owned Coin/Credit Card Phones
To comply with state tariffs, the telephone company must be given notification
prior to connection. In some states, the state public utility commission, public
service commission or corporation commission must give prior approval of
connection.
Part 15 of FCC Rules Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Your equipment has been tested and found to comply with the limits of a Class
B digital device, pursuant to Part 15 of FCC rules. These limits are designed
to provide reasonable protection against harmful interference in residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation; if this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, you are encouraged to try to
correct the interference by one of the following measures:
1. Where it can be done safely, reorient the receiving television or radio
antenna.
2. To the extent possible, relocate the television, radio or other receiver with
respect to the telephone equipment. (This increases the separation between
the telephone equipment and the receiver.)
3. Connect the telephone equipment into an outlet on a circuit different from
that to which the television, radio or other receiver is connected.
4. Consult the dealer or an experienced Radio/TV Technician for help.
Privacy of communications may not be ensured when using this phone.
WARNING: To maintain the compliance with the FCC's RF exposure guideline,
place the base unit at least 20 cm from nearby persons.
34

Publicité

Table des Matières
loading

Table des Matières