Button Functions - Uline H-9424 Mode D'emploi

BUTTON FUNCTIONS:

NOTE: Battery must be fully charged before first use.
INSTALL FUSE
1. Disconnect hoses from recovery tank and remove
tank. Insert fuse. (See Figures 1 and 2)
Figure 1
2. Snap tank into position and place lid on top.
Reconnect hoses to back of tank.
(See Figures 3 and 4)
Figure 3
ASSEMBLE SQUEEGEE
1. Raise squeegee mounting bracket by pulling up
squeegee release handle. Position squeegee bar so
wheels face backward. (See Figures 5 and 6)
Figure 5
PAGE 5 OF 39
GENERAL INFORMATION CONTINUED
Power
Brush
Figure 2
Figure 4
Figure 6
ASSEMBLY
2. Insert squeegee into slots on squeegee mounting
bracket. Turn yellow knobs clockwise to tighten.
Attach hose. (See Figure 7)
Figure 7
INSTALL BRUSH
1. Turn on brush only. Position brush on floor; move
scrubber over it. (See Figures 8 and 9)
Figure 8
2. Pull drive levers to activate scrubber and spin on
brush. Brush will spin smoothly once seated correctly.
(See Figures 10 and 11)
Figure 10
Battery
Indicator
Water
Fan
Figure 9
Figure 11
0622 IH-9424