Uline H-9424 Mode D'emploi

H-9424
20" AUTO FLOOR SCRUBBER
NOTE: This guide is intended for quick reference
only and does not replace the instruction manual.
Before using this machine, read full instruction
manual included with machine packaging.
NOTE: Battery must be fully charged before first
use.
FILL TANK
1. Add water and/or detergent into the tank.
(See Figure 1)
Figure 1
NOTE: Use a low-foaming detergent with a pH
range between 7 and 11 (Uline model #S-18933).
Be sure to follow the detergent instructions for
proper dilution.
2. Open flow from detergent tank by pushing lever up
to horizontal position. Leave open. (See Figure 2)
Figure 2
BEGIN WORK
1. Lower squeegee by pushing handle down.
(See Figure 3)
Figure 3
PAGE 1 OF 9
1-800-295-5510
uline.com
OPERATION
2. Turn on unit and press brush button. All lights will light
up and unit is fully functional. (See Figures 4 and 5)
Figure 4
3. Pull drive levers to begin work.
4. After use, empty the recovery tank by using the
attached drain hose. (See Figure 6)
Figure 6
5. Once finished, charge the battery.
NOTE: The battery should be charged after
every use. For optimal battery life, leave
plugged in when not in use.
WHEN FINISHED CLEANING
1. Turn machine off by pressing the On/Off button for at
least four seconds.
2. Empty the recovery tank (see Maintenance).
3. Raise squeegee and wipe down blade with a soft
cloth.
4. Close the detergent tap.
5. Spin off brush (see Maintenance). Rinse.
6. Charge the battery (see Maintenance).
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
Figure 5
0722 RH-9424