Uline H-9424 Mode D'emploi page 11

OPERATING ISSUE
The machine does not work.
The brush does not rotate.
The machine does not
clean evenly.
Reduced power or speed.
No detergent is delivered.
The suction motor does not
start.
PAGE 11 OF 39
TROUBLESHOOTING
CAUSES
The batteries need to be charged.
The brush button LED is off.
The brush motor thermal cutout has
tripped; the motor has overheated.
The batteries need to be charged.
The brush motor fuse has blown.
The brush or floor cleaning pad is
worn.
Unit may be in ECO mode.
• This mode runs unit at 80% power
resulting in reduced noise for use
in noise-sensitive environments.
• Indicator light for the motor
(brush motor or fan motor) will
show a slow blink.
The detergent button LED is off.
The detergent tank is empty.
The brush motor is off.
The hose delivering the detergent
to the brush is blocked.
The detergent tap is dirty or faulty.
The in-line filter is dirty (left side from
operator's position near the wheel).
The fan button LED is off.
The vacuum motor fuse is blown.
RECOMMENDATIONS
Charge the batteries.
Press the brush button.
Turn off the unit. Let the machine
cool down for at least 45 minutes.
Charge the batteries.
Replace the brush motor fuse.
Replace the worn brush or floor
cleaning pad.
Turn off ECO mode.
• Hold button for applicable motor
(brush or fan) for 10-15 seconds
until light turns solid.
Press the detergent button.
Fill the detergent tank.
Turn on the motor by pressing the
brush button.
Unblock and open the detergent
tank tap.
Have the detergent tap cleaned or
replaced.
Clean the filter. Make sure to close
the detergent tap prior to cleaning.
Press the fan button.
Replace the vacuum motor fuse.
0622 IH-9424