hager EE807 Mode D'emploi page 4

Settings available
Key Meaning
Presence
Absence
Power Up
Reset
Test
Time
Day level
1000 Lux
Direct lighting/ long press
(> 10 s.)
Learn
Indirect lighting/ long press
(> 10 s.)
Corridor
200 Lux
Office
400 Lux
Lux +
Lux –
Active cell
Passive cell
Memo and SET keys
Key Meaning
Press
Long press
Press
Long press
Short press (<5s)
Long press (>5s but <10s)
only available if no setting
active.
4 www.hager.com
Indication
Green LED on
Red LED on
Green LED on
Red LED on
LED on
LED on
LED on
LED on
The red LED of the detector blinks.
LED on
The red LED of the detector blinks.
LED on
LED on
LED on
LED on
Green LED on
Red LED on
Indication
LED is on until a setting is changed.
LED is on during 5s., then blinks until release press.
After release, the LED goes off in case of setting
change.
LED is on until a setting is changed.
LED is on during 5s., then blinks until release press.
After release, the LED goes off in case of setting
change.
LED flashes.
LED blinks until release press.
Function
Presence on (automatic mode).
Absence on (semi automatic mode).
The light is automatically switched ON for
30 s after power up.
During warm up phase, the light output is off.
To return to factory settings
(Lux = 400, time = 20min., presence on,
power up off and cell active).
To validate the detection area
To set the time.
It is possible to add times
Ex.: press 2' and 5', time value is 7'.
To set the value on 1000 Lux
To control a direct lighting.
To learn the current Lux level
To control an indirect lighting.
To set the value on 200 Lux
To set the value on 400 Lux
To increase the Lux level (+100)
To decrease the Lux level (-100)
The light is continuously measured.
The product doesn't switch the light off even
if the ambient luminosity is sufficient.
Function
To load/unload Memo 1.
To save the current setting as Memo 1.
To load/unload Memo 2.
To save the current setting as Memo 2.
To send an IR message of the current setting.
To toggle automatic mode on DALI/ DSI
detectors (EE816, TCC521E).
6E 7610C