fadini Junior 633 Notice D'instructions page 33

JUNIOR 633
JUNIOR 650
GUIDANCE FOR PROPER USE (for the end user)
WARNINGS
• Transit across the gate is allowed only if motor is stopped; stand at safe distance during opening and/or closing cycles of the gate.
• Do not touch any components of the system while the operator is working.
• Do not allow children and/or people to stand in the proximity of a working operator.
• Keep all the accessories able to turn on the operator (transmitters, proximity readers, key-switches, etc.) out of the reach of the children.
• Do not run the system in case of anomalies.
DISPOSAL OF MATERIAL: dispose properly of the packaging materials such as cardboard, nylon, polystyrene etc. through specializing
companies (after verification of the regulations in force at the place of installation in the field of waste disposal). Disposal of electrical and
electronic materials: to remove and dispose through specializing companies, as per Directive 2012/19/UE. Disposal of substances
hazardous for the environment is prohibited.
MAINTENANCE
For optimum performance of system over time according to safety regulations, it is necessary to perform proper maintenance and
monitoring of the entire installation: the automation, the electronic equipment and the cables connected to these. The entire installation
must be carried out by qualified technical personnel. Operator: maintenance inspection at least every 6 months, while for the electronic
equipment and safety systems an inspection at least once every month is required. The manufacturer, Meccanica Fadini snc, is not
responsible for non-observance of good installation practice and incorrect maintenance of the installation.
Advice for the end user:
• clear the site of materials that may have deposited in the equipment and hinder its correct functioning (such as rests of insects, foliage,
stones, etc.); before carrying out this operation, switch off voltage supply;
• clean regularly the equipment by using a damp cloth. Do not use flammable substances such as alcohol, solvents or benzene: these
substances may cause explosions and/or damage the system.
LOCKING AND UNLOCKING THE GEARED MOTOR
This manual operation is to be carried out in case of
power failure or faults detected with the systems.
By opening the unlocking handle with the coded key,
the electrical power supply is always disconnected
from the system. For unlocking action and
subsequent manual movement of the gate, it is
necessary that the handle be opened until it stops
beyond 90°. Upon closing and subsequent locking of
the lock, the electrical power supply to the PCB is
reset.
IMPORTANT: once the electrical power supply has
been disconnected using the unlocking key, upon
return of the mains electrical power, the first
movement of the Junior operator is always towards
closing at a normal operational speed with no
programmed slowdowns. All of the programmed
functions are resumed completely with the next
complete cycle (opening-pause-closing).
electro-mechanical sliding gate operator
E
1
Insert the customised
key
33
2 3
Turn the key: power
supply is disconnected
(blue light off)
Open the handle:
fully open the handle
to its stop
+90°
Pic. 14