Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembling your Pocket-Pro
1) Attach the jig to a flat piece of plywood or your workbench.
See illustrations below for suggested dimensions. Screws
should be tight enough to keep the jig from moving on the
plate, but do not overtighten and damage your jig.
2) Assemble the molded Upper Jig to the Jig Base using the
two screws and knobs provided.
3 Attach the Toggle Clamp to the base you constructed in
Step One using four screws. Thread the shaft of the Clamp
Tip into the body of the Toggle Clamp.
Fig. 3
Mounting Holes for
Molded Jig
www.cmtorangetools.com
M4 screw
14-3/4"
375mm
M4 screw
1-5/8"
1-1/2"
1-3/8"
1-1/4"
1-1/8"
1"
7/8"
3/4"
5/8"
Fig. 1
1/2"
Base Plate
M8 screw
1-5/8"
1-1/2"
1-3/8"
1-1/4"
1-1/8"
1"
7/8"
3/4"
5/8"
Fig. 2
1/2"
Tip
1-5/8"
1-1/2"
1-3/8"
1-1/4"
1-1/8"
1"
7/8"
3/4"
5/8"
1/2"
Mounting Holes
for Molded Jig
EN
Knob
3
Publicité
Table des Matières
