Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Problem
Tool will not start.
1.
Cord not connected.
2.
No power at outlet.
3.
Tool's thermal reset breaker
tripped (if equipped).
4.
Internal damage or wear.
(Carbon brushes or switch, for
example).
5.
Head bolts too tight.
Tool operates slowly.
1.
Dirty, worn or damaged blades.
2.
Extension cord too long or wire
size too small.
3.
Head bolts too tight.
Performance
1.
Blades dull or damaged.
decreases over time.
2.
Carbon brushes worn or
damaged.
Cut not smooth.
Head bolts loose.
Excessive noise or
Internal damage or wear. (Carbon
rattling.
brushes or bearings, for example.)
Overheating.
1.
Forcing tool to work too fast.
2.
Blades misaligned.
3.
Blades dull or damaged.
4.
Blocked motor housing vents.
5.
Motor being strained by long or
small diameter extension cord.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
TROUBLESHOOTING
Possible Causes
Likely Solutions
1.
Check that cord is plugged in.
2.
Check power at outlet. If outlet is unpowered,
turn off tool and check circuit breaker. If breaker
is tripped, make sure circuit is right capacity for
tool and circuit has no other loads.
3.
Turn off tool and allow to cool. Press reset button
on tool.
4.
Contact Customer Service for repair.
5.
Make sure that head bolts are not
excessively tight.
1.
Clean or replace blades.
2.
Eliminate use of extension cord. If an extension
cord is needed, use shorter/heavier gauge cord.
See Extension Cords in
section.
3.
Make sure that head bolts are not
excessively tight.
1.
Keep blades sharp. Replace as needed.
2.
Contact Customer Service to have brushes
replaced.
Tighten head bolts enough to properly hold the
left and right blades in place.
Contact Customer Service for repair.
1.
Allow tool to work at its own rate.
2.
Check and correct blades to fence and/or table
alignment.
3.
Keep blades sharp. Replace as needed.
4.
Wear ANSI-approved safety goggles and NIOSH-
approved dust mask/respirator while blowing dust
out of motor using compressed air.
5.
Eliminate use of extension cord. If an extension
cord is needed, use one with the proper diameter
for its length and load. See Extension Cords in
SAFETY INSTRUCTIONS section.
SAFETY INSTRUCTIONS
17
Publicité
Table des Matières
