Philips HP6370 Mode D'emploi page 17

Problem
The appliance
does not work
properly during
trimming and
does not cut
long hairs.
The precision
trimming head
with comb
produces an
uneven cut.
Solution
If the above-mentioned solutions do not solve the
problem, you have to replace the shaving head or
the precision trimming head. Take the shaving head
or precision trimming head to your dealer or the
nearest Philips service centre.
Make sure that the batteries are charged sufficiently
and that the comb is attached correctly.
Make sure that you clean the appliance properly (see
chapter 'Cleaning and maintenance').
Make sure that the flat part of the comb is in contact
with the skin to obtain an even result. Do not put
the appliance on the skin too steeply.
If the above-mentioned solutions do not solve the
problem, take the appliance to your dealer or the
nearest Philips service centre.
Do not press the precision trimming head with
comb too firmly onto the skin, as this may cause a
shorter hair length than 3mm or 5mm. Make sure
that the front part of the comb is always fully in
contact with the skin. Move the trimming head
against the direction of hair growth. Move the
trimming head in different directions (upwards,
downwards and across), as not all hairs grow in the
same direction.
EnglisH
17