A1.1 Electromagnetic Emissions - For All Equipment And Systems; A1.2 Electromagnetic Immunity - For All Equipment And Systems - EDAN INSTRUMENTS SONOTRAX Serie Manuel D'utilisation

Manuel Utilisateur de Série de Poche Ultrasonique Doppler SONOTRAX
Appendix
Manufacture's Declaration
A1.1 Electromagnetic Emissions - for all Equipment and
Systems
Guidance and manufacture's declaration–electromagnetic emission
The SONOTRAX Series Ultrasonic Pocket Doppler is intended for use in the electromagnetic
environment specified below. The customer or the user of the device should assure that it is used in such
an environment.
Emission test
RF emissions
CISPR 11
RF emission
CISPR 11
A1.2 Electromagnetic Immunity - for all Equipment and
Systems
idance and manufacture's declaration–electromagnetic immunity
Gu
The SONOTRAX Series Ultrasonic Pocket Doppler is intended for use in the electromagnetic
environment specified below. The customer or the user of the device should assure that it is used in such
an environment.
Immunity test
Electrostatic
discharge (ESD)
IEC 61000-4-2
A EMC
Compliance
The SONOTRAX Series Ultrasonic Pocket Doppler uses RF
energy only for its internal function. Therefore, its RF emissions
Group 1
are very low and are not likely to cause any interference in nearby
electronic equipment.
The SONOTRAX Series Ultrasonic Pocket Doppler is suitable
for use in all establishments, including domestic establishments
Class B and those directly connected to the public low-voltage power
supply network that supplies buildings used for domestic
purposes.
IEC 60601 test
level
±6 kV contact
±8 kV air
Information-Guidance
Electromagnetic environment–guidance
Compliance level
±6 kV contact
±8 kV air
- 25 -
and
Electromagnetic
environment-guidance
Floors should be
concrete or ceramic tile. If
floor are covered
synthetic material, the relative
humidity should be at least
30%.
wood,
with