Basic Tips - Mousetrapper Prime MTkeys Mode D'emploi

English
1 Connecting Mousetrapper
Installation
Connect the supplied USB cable to the socket on the left side
of your Mousetrapper, and connect the other end to a USB
port on the computer. Once installed, your Mousetrapper and
its buttons will operate as shown in figure 2.
Wireless use
Open the battery compartment cover and connect the
battery. Remove the USB dongle from the right-hand
side of the product and insert it into a USB Port on the
computer. Then disconnect the USB cable.
Charging the battery
The battery in the Mousetrapper needs charging when the
battery indicator flashes red. Connect the Mousetrapper
using the included USB cable and allow it to charge until
the LED indicator shines green.
Changing from Mac to PC configuration
The product is configured for PC on delivery. To configure it
for Mac, simultaneously depress the lower right button and
the lower left button (Copy and Paste) for 3–4 seconds. The
LED will flash red to confirm the configuration. Repeat the
procedure to change back to PC configuration.
2

Basic tips

Positioning
Position your Mousetrapper between you and your
keyboard. The space bar on the keyboard should be
directly in front of the control pad, as shown in figure 1.
If you have a low keyboard, unfold the keyboard support
from underneath your Mousetrapper and place the
keyboard on top of it.
Scrolling
To scroll using the control pad, place your finger on the
right edge of the control pad. There is no need to press on
the control pad, simply slide your finger up or down the
edge, depending on which way you want to scroll.
Replacement of pads
The pads can be replaced when they are worn out. To
remove a pad, insert a flat tool between the frame and the
Mousetrapper and gently prise the frame/pad out of the
Mousetrapper. You can order new pads via your dealer or
directly from Mousetrapper.
3 Customising
MT Keys
To customise the button functions, go to
mousetrapper.com/mtkeys and download the software.
If you have Windows 10, you can download MT Keys from
Microsoft Store.
NOTE: In order to use MT Keys, the cable must be
connected.
When you have downloaded MT Keys, an image of the
product will appear that matches the image underneath your
Mousetrapper. Position the cursor over the button you want
to customise. Click on it by lightly pressing on the control
pad once. You will now see a pull-down menu that lets you
assign whichever action you want to that button. You can
choose between functions such as adding an extra left-click,
creating shortcuts and inserting text by pasting it in.