Sauder Dakota Pass 422592 Mode D'emploi page 16

Step 12
IMPORTANT: You will need someone's help in this step.
å
NOTE: Be careful when lining up the holes in the LIFT TABLE MECHANISMS (23M) with the holes in the ENDS (A and B)
å
as to not damage any parts.
Fasten the TOP (D) to the ENDS (A and B). Use ten BLACK 9/16" LARGE HEAD SCREWS (1S) through the LIFT TABLE
å
MECHANISMS (23M) and into the holes in the ENDS.
NOTE: You should start each SCREW a few turns before completely tightening any of them. You will have to lift up on the
å
back of the LIFT TABLE MECHANISMS to fi nd the back holes.
Do not insert
a SCREW
into this hole.
Page 16
D
23M
A
422592
23M
Do not insert
a SCREW
into this hole.
BLACK 9/16" LARGE HEAD SCREW
(10 used in this step)
These four holes
must be here.
B
1S
www.sauder.com/services