Sauder Dakota Pass 422592 Mode D'emploi page 13

Step 9
Carefully stand your unit upright.
å
Fasten the PANEL MOLDINGS (M) to the PANELS (J). Use
å
six SILVER 1-1/8" FLAT HEAD SCREWS (10S).
NOTE: There are no pre-drilled holes in the PANEL
å
MOLDINGS. The SCREWS will tighten into the grooves.
Center a SCREW COVER (20P) over the head of each
å
SCREW and press fi rmly.
Push six BUMPERS (2M) into the LEGS (H and I)
å
and PANELS (J).
NOTE: You may need to gently tap the BUMPERS in with
å
your hammer.
SILVER 1-1/8" FLAT HEAD SCREW
(6 used in this step)
The groove is
closer to this edge.
www.sauder.com/services
10S
H
2M
M
I
The top edges of the PANELS and
PANEL MOLDINGS should be even.
422592
Pro Tip: Lift with your
legs. And, you know,
your arms.
To cover screws (10S)
20P
I
J
J
M
(6 used)
H
Page 13