Beper P101FRI050 Mode D'emploi page 10

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
Digital Air Fryer Use instructions
General description Fig.A
1. Housing
2. Digital control panel
3. Removable basket
4. Basket handle
5. Air outlet openings
6. Power cable
7. Basket rack
Control panel description Fig. B
A. On / Off button
B. Temperature selection button
C. Time and temperature display
D. Re-heat
E. Frozen French fries /snacks
F. Shrimps
G. Fish
H. Chicken
I. Meat
J. Vegetables
K. Ventilation indicator
L. Heating indicator
M. Preset menu selection key (marked with M)
N. Timer selection key
First use
Remove all packaging materials and check that all parts will be inside and not damaged.
Wash all parts by following the instruction shown on section" cleaning"
Usage
Place the appliance on a stable, horizontal, even and hot resistant surface.
Check if the voltage indicated on the appliance fits the local mains voltage and plug in.
Remove the basket, place the grid and then insert the ingredients into the basket, taking care to keep at least two centime-
ters from the upper edge of the basket.
Check the cooking time and temperature required for the different ingredients before starting (see table).
Insert the basket.
Do not touch the basket during and after use, as it is very hot. Only handle it using the appropriate handle and using an
oven glove or pot holder.
Press the "A" button to turn on the device.
The control panel turns on and the default temperature and time will be displayed in quick succession.
Use the "M" key to set the cooking program from those preset according to the food to be cooked or the manual program.
The relative light will light up cyclically and the temperature and cooking time will be automatically set.
In the case of manual operation (all the lights referring to food are off) the appliance will operate based on the manually set
temperature and time data.
Whether using a preset program or using a manual program, it is possible to vary the temperature settings by 5 ° C at a
time and the cooking time by pressing the relative + and - keys.
Press the "A" key again.
The appliance starts to work and the ventilation and heating lights light up. The display also shows the set temperature and
the remaining cooking time.
The excess oil of the ingredients will be collected at the bottom of the basket under the grill.
Some ingredients require mixing halfway through the preparation time (see table), however it is recommended that you mix
the food when filling the basket to more than half its capacity. To mix the ingredients, remove the basket from the appliance
using the special handle, mix, then slide the basket back into the fryer.
At the end of cooking you will hear an acoustic signal, remove the basket from the appliance and place it on a plate. Check
if the ingredients are ready, if they are not put the basket back in the fryer and set the timer for a few more minutes.
It is possible to stop cooking by pressing the "A" key.
The device keeps the ventilation active for a few seconds before turning off and emitting an acoustic signal; if key "A" is
pressed again before the fryer switches off completely, the cooking cycle resumes from where it was interrupted.
10

Publicité

Table des Matières
loading

Table des Matières