Cleaning And Maintenance - Lanaform Aqua Pleasure Mode D'emploi

The control panel setting can be locked. To do this, hold down the buttons for increasing and decreasing the temperature
simultaneously for three seconds. To unlock the control panel, repeat this process.
DRAINAGE
To empty the spa bath, follow the instructions below:
1. Turn off all the bath functions and disengage the pump.
2. Connect the drainage adaptor (diagram 1.K.) supplied with the spa bath, by screwing it into the drainage outlet hose
(diagrams 1.H and 8.A.).
3. Connect the other end of the drainage adaptor to a garden hose (not supplied) using a clip available from any specialist
supplier.
4. Open the drainage valve at the base of the bath to empty the water (diagram 8.B.).
5. Gently tilt the spa bath using the handles, to allow any remaining water to drain out.
6. Remove the filter and empty the water from the pump, ensuring that it has been fully unplugged beforehand. We also
recommend that you unscrew the drainage valve on the pump (diagram 8.C.) and empty it of water.
7. Then plug in the pump and use the massage function to dry the inside of the pump as illustrated in diagrams 8.D.
and 8.E.
8. Finally, dry the spa bath and the pump.

CLEANING AND MAINTENANCE

CLEANING
During use, residue from detergents and chemical products (pH, chlorine, etc.) will gradually accumulate in the spa bath.
To clean the tub, use soap and water, and then rinse. For water maintenance, consult the directions described in the
relevant section.
NOTE:
Do not use abrasive cleaners or hard brushes to clean the spa bath.
STORAGE
Before storing the unit, check that there is no water left in the tub or in the pump in order to extend its lifetime. Ensure
that the tub is clean and dry, as well as the filter pump and various hoses. Remove the pump cover and take out the filter
cartridge. You are advised to store the spa bath in its original packaging in a warm, dry place.
NOTE:
plastic can become brittle and susceptible to cracking if exposed to sub-zero temperatures. Freezing can seriously
damage the bath. Damage caused by inappropriate winter storage may invalidate your warranty.
REPAIR OF THE SPA BATH
If the surface of the spa bath is damaged, use the repair kit provided. Dry the area to be repaired; apply the glue supplied
in the kit to the repair patch, and affix it to the damaged area. Smooth the surface to remove any air bubbles.
FILTER MAINTENANCE
WARNING:
Ensure that the pump is fully unplugged before undertaking maintenance, to avoid risk of injury or
electrocution.
1. To prevent water draining from the pump, place the two adaptors (diagram 1.G.) onto the two connectors on the
inner wall of the spa bath. This will prevent water from escaping during cleaning or replacement of the filter cartridge.
2. Clear the air from the pump by unscrewing the bleed valve at the top of the pump as described above (diagram 6).
Aqua Pleasure
EN
11