Control Panel - Lanaform Aqua Pleasure Mode D'emploi

8. Place the safety cover (diagram 1.A.) on the spa bath and attach it using the zip closure. A padlock is supplied with
EN
the unit to secure the tub.
How to change the padlock combination
- The default combination is 000.
- Press the black button while selecting your own code using the number wheels.
WARNING:
around the spa bath.
OPERATION OF THE PUMP
BLEEDING THE PUMP VALVE
WARNING:
The operation of your spa bath may be affected if you do not follow the instructions below. Never run the
pump without water. Any resulting damage will not be covered by the warranty.
NOTE :
To ensure proper operation of the device, it is essential to bleed the pump filter before each use to release the air
inside it.
1. Open the air release valve at the top of the pump by turning the knob anticlockwise. For maximum ventilation, give
two full turns of the pump valve. More than two full turns may detach the pump valve (diagram 6.1.).
NOTE:
if the knob does become detached, simply replace it and turn it clockwise to reposition the air release valve.
2. Once the pump valve is open, water will begin to flow round the pump, releasing the air in the system. This process will
take about 1 minute, depending on the amount of water in the spa bath and in the pump.
3. Close the valve by turning it clockwise.
4. Once the pump valve is cleared of trapped air, wipe up any excess water from the pump.

CONTROL PANEL

(Diagram 7)
When lit up, the LED control panel shows the current water temperature automatically.
7.A. Hydro jet massage button: use this button to activate the massage system, which shuts off automatically after
30 minutes. When the spa bath is in massage mode, the filter is turned off. Also the massage function cannot be
activated at the same time as the water heater.
7.B. Water filter button: this button turns the water filter pump on and off. The light above the water filter button glows
blue when the pump is activated.
7.C. Water heater button: use this button to activate the water heater. The pump heats the bath until the water
temperature is 1°C higher than the temperature level set. The heating system will restart when the temperature falls
2°C below the set level. The button indicator flashes when the heater is activated. The heating system can increase
the temperature quickly, by approximately 1.5 to 2°C (3-4°F) per hour.
NOTE :
when the heating system is on, the filter system stops automatically. This is normal.
When the heating system is turned off, the filter system turns on again. Again, this is normal.
7.D. Temperature mode (°C/°F): The temperature can be displayed in both Fahrenheit and Celsius. To switch from one to
the other, press this button.
7.E&7.F. Raising and lowering the water temperature: the indicator lights flash when the raise/lower temperature button
is pressed. While they are flashing, you can select the desired temperature. When the buttons are held down, the
values rise or fall rapidly. The new temperature setting will remain displayed for 5 seconds.
NOTE:
40°C (104°F).
10
The protective cover is not a substitute for adult supervision; children should always be supervised
the default temperature setting is 40°C (104°F) on first start-up. It can be adjusted from 20°C (68°F) to