vds LINEAR 11 Manuel Technique page 15

INSTALLATION OF FASTENING PLATES
Fix the back plate to the
pillar.(FIG. 1)
Anchor the rear part of the piston
to the plate and fasten it firmly
( FIG. 2)
(FIG. 2)
Warning! When establishing the height off the ground at which to fasten the plate to the post
(fig. 1), keep in mind that the plate for anchoring the piston to the gate must be fastened at the
same level (fig. 3)
Installing the anchor plate on the piston to the gate
1. Fit the anchor plate onto the piston (fig. 4)
2. Close the gate
3. Move the piston with the plate already fitted
towards the gate
4. Move the fitting to limit stop, then move it
back by approximately 1 cm and mark the
position of the plate.
5. realize the same operation in opening.
6. If positions correspond, fix the plate on the
gate; otherwise revise A and B units (table 1)
Release procedure
To unblock the operator, use
the key as shows the photo.
Turning the key of 90°, the
operator will be completely
unblocked.
Blocked
(FIG. 1)
(FIG. 3)
(FIG. 4)
Unblocked