Connecting The Reader In 26-Bits Wiegand - Eden ACCESS IT Notice Technique

Wiring diagram
Technical information SOLO – 12 June 2008 – V1.0

2) Connecting the reader in 26-bits WIEGAND

Data sheet:
(?)
5 wires (3 pairs recommended)
150 m
0.6 mm (SYT recommended)
±
Characteristic: Sensitive connection
Screen: Recommended
Simply connect the three wires on the reader and the power supply to the control unit terminal block as
shown.
Note: Do not position the control unit-reader wires close to other live or high voltage cables, and
specifically not close to 220 V cables or higher.
Note: In 26-bit WIEGAND, using badge plus fingerprint, the serial number of the MIFARE badge will be
sent in 24 bits framed by 2 parity bits. Using fingerprint recognition only, a number corresponding to the
order of enrolment will be sent in 24 bits framed by 2 parity bits (example, first user enrolled, number 1
sent, second user enrolled, number 2 sent etc.). If a fingerprint is not recognised or the badge is an off-
site one, the number 65535 will be sent.
+12V
0V
Data 1
Data 0
LED
third-party control
Note: If you use an external power source to
power SOLO, ensure that you connect the
earth to the one on the control unit.
p.15/20
ACCESS IT Unit
or
unit