Electromagnetic Compatibility Information - Mx Onda MX-CP2395 Manuel D'instructions

ELECTROMAGNETIC COMPATIBILITY INFORMATION

Guidance and manufacture's declaration - electromagnetic emissions
The MX-CP2395 is intended for use in the electromagnetic environment specified below.
The customer or the user of the MX-CP2395 should assure that it is used in such an environment.
Emissions test
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/ flicker
emissions IEC 61000-3-3
Guidance and manufacturer's declaration - electromagnetic immunity
The MX-CP2395 is intended for use in the electromagnetic environment specified below. The customer or the user
of the MX-CP2395 should assure that it is used in such an environment.
IMMUNITY test
Electrostatic discharge
(ESD) IEC 61000-4-2
Power frequency
(50/60 Hz) magnetic
Field IEC 61000-4-8
Table 1: For all ME EQUIPMENT and ME SYSTEMS
Compliance
Group 1
Class B
Not
applicable
Not
applicable
Table 2: For all ME EQUIPMENT and ME SYSTEMS
IEC 60601test Compliance
level
± 6 kV contact ± 6 kV contact
± 8 kV air ± 8 kV air
3 A/m 3 A/m
Electromagnetic environment - guidance
The MX-CP2395 uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
The MX-CP2395 is suitable for use in all establishments other
than domestic and those directly connected to the public low-
voltage power supply network that supplies buildings used for
domestic purposes.
Electromagnetic environment - guidance
level
Floors should be wood, concrete or ceramic tile.
If floors are covered with synthetic material, the
relative humidity should be at least 30 %.
Power frequency magnetic fields should be at
levels characteristic of a typical location in a
typical commercial or hospital environment.
29