Uline CUBITAINERS S-18116 Guide Rapide

S-18116
S-18117
CUBITAINERS
®
NOTIFICATION FOR ULINE UN/DOT PACKAGING FOR HAZARDOUS SOLIDS/LIQUIDS
Please note that under the U.S. Department of Transportation's Title 49CFR, Section 173.22, it is the Shipper's
Responsibility to ensure that an authorized package has been selected for the product they intend to offer
for transportation and that the selected package is properly closed for transportation in accordance with the
manufacturers notification.
Please do any and all testing and research necessary to ensure you have selected the proper container for use with
your product.
To meet UN/DOT Standards, this package must be properly closed for shipment. Closing instructions have been
included below. Failure to follow the closure instructions will render the UN/DOT Certification invalid.
Use of non-specified components will lead to non conformance with DOT marks. If you are not the final assembler,
you are required to transfer this information to the party who will complete assembly of this package in accordance
with 49 CFR para. 178.2.
In accordance with the U.S. Department of Transportation's Title 49CFR, Section 178.2, manufacturers of U.N. Standard/
DOT Specification packages are required to notify in writing each person to whom that packaging is transferred of
all requirements in this part not met at the time of transfer, and with information specifying the type(s) and dimensions
of the closures, including gaskets and any other components needed to ensure that the packaging is capable
of successfully passing the applicable performance tests. This information must include any procedures to be
followed, including closure instructions for inner packagings and receptacles, to effectively assemble and close the
packaging for the purpose of preventing leakage in transportation.
CLOSING INSTRUCTIONS
1. Place 38–400 mm copolymer polypropylene screw cap with polyethylene foam liner cover (included) on mouth
of container.
2. Tighten screw cap using a torque application of 25 in-lbs.
3. After the screw cap is tightened, the dust cover must be taped in place with 2" wide tape. Extend tape at least 2"
down each side panel.
CAUTION! The assembled Cubitainer®is not authorized for air transport of hazardous materials.
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTRUCTIONS
Para Español, vea página 2.
Pour le français, consulter la page 3.
0621 IS-18116