Uline S-15286 Notice D'utilisation

S-15286
SERVICE KIT FOR
L-BAR SEALER
CHANGING PARTS
REPLACING HEATING ELEMENT WIRE
1. Remove plastic cover from front post.
®
2. Remove Teflon tape on both the top and bottom
sealing arms.
3. Remove screw attaching heating element to post,
located under plastic cap.
4. Remove heating element.
5. Remove rear top cover plate to expose rear post.
6. Attach new heating element to front post with screw.
7. Feed heating element through channel.
PAGE 1 OF 3
1-800-295-5510
uline.com
OPERATING INSTRUCTIONS
Plastic
Cover
Washer
Spring
REMOVE PLUG FROM OUTLET BEFORE INSTALLATION
Screw
Teflon Tape
Heating
Element
Screw
Post
8. Use flathead screwdriver to compress spring on rear
post.
9. Attach heating element to rear post.
10. Replace top cover.
11. Replace plastic cover on front post.
®
12. Cut new Teflon tapes in half to create four, 18" strips.
Place two on the top sealing arms and two over the
bottom sealing wires.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0721 IS-15286