Table des Matières
Publicité
BEFORE THE ENGINE CAN BE STARTED
BEFORE THE ENGINE CAN BE STARTED
BEFORE THE ENGINE CAN BE STARTED
BEFORE THE ENGINE CAN BE STARTED
BEFORE THE ENGINE CAN BE STARTED
1.
Ensure, the seat is adjusted correctly for the
operators weight.
2.
Ensure the transmission footpedal is in its
neutral position.
3.
Ensure the cutting unit drive switch on the
control panel is off (not illuminated).
If any of the above are not set correctly, the engine
will not start.
TO START THE ENGINE
TO START THE ENGINE
TO START THE ENGINE
TO START THE ENGINE
TO START THE ENGINE
Turn the keyswitch to the 'PREHEAT' position,
when the glow plug warning light goes out
continue turning the key to the 'START'
position. When the engine has started, release
the key and allow it to return to the 'ON' position.
IMPORTANT NOTES -
IMPORTANT NOTES -
IMPORTANT NOTES -
IMPORTANT NOTES -
IMPORTANT NOTES -
Always allow the engine to warm up sufficiently before
full load and speed is applied, otherwise the life of the
engine will be shortened.
WARNING NOTES -
WARNING NOTES -
WARNING NOTES -
WARNING NOTES -
WARNING NOTES -
(a) Do not turn key whilst engine is running.
(b) If the engine fails to start within 10 seconds of
switching on, wait for a further 30 seconds
before attempting to start the engine again.
(c)
Do not allow the starter motor to run for more
than 30 seconds, otherwise failure of the starter
motor may result.
TO STOP THE ENGINE
TO STOP THE ENGINE
TO STOP THE ENGINE
TO STOP THE ENGINE
TO STOP THE ENGINE
(a) Return the speed control lever to the "idle"
position.
(b) Turn the key to the "off" position and remove
the key.
TO SLOW DOWN AND STOP THE MACHINE
TO SLOW DOWN AND STOP THE MACHINE
TO SLOW DOWN AND STOP THE MACHINE
TO SLOW DOWN AND STOP THE MACHINE
TO SLOW DOWN AND STOP THE MACHINE
(a) Gradually release the pressure on the foot pedal
to allow the pedal to return to neutral and the
machine will come to a halt.
(b) Disengage the drive to the cutting cylinders by
switching off the rocker switch (not illuminated)
on the control panel, If the units have not been
raised.
(c)
Apply parking brake.
TO REVERSE
TO REVERSE
TO REVERSE
TO REVERSE
TO REVERSE
The rear of the RH footpedal should be depressed
gently to obtain reverse motion of the machine.
NOTE: DO NOT move footpedal violently from
forward to reverse or vice versa. Always operate
slowly and smoothly.
GB
GB
GB
GB
GB
`
Publicité
Table des Matières
