Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Install the driver side latch assembly as in step 1.
Use a 6 inch 1/4" drive extension to aid in access
to the nut. See Figure 2.
2
Install the hood catch onto the hood of the
vehicle using the Allen head bolts, small star
washers and small Nylock nuts.
IMPORTANT, place the small star washers
under the head of the bolts on top of the catch
not inside the hood. See Figure 3.
Use the flat washers and the nylocks to fasten
the catch. The slots should allow some
adjustment to the catch. See Figure 4.
Repeat for other side.
3
Use Instructions
Fold latch down and hook over catch on hood with hood closed and then fold latch assembly down
solidly. Use key to lock the assembly in the hooked position. Check the lock to be sure it is hooked
properly by pulling up on the rear section.
CAUTION: Be sure to check the tightness of all fasteners periodically to ensure the hood stays
latched properly while driving. Be sure the latch is tight and the locks are locked as instructed
above.
Congratulations!
You have purchased one of the many quality Rampage branded products offered by Lund International. We take the
utmost pride in our products and want you to enjoy years of satisfaction from your investment. We have made every
effort to ensure that your product is top quality in terms of fit, durability, finish and ease of installation.
• Visit us at Rampageproducts.com
© 2018 Lund Motion Products, Inc. All rights reserved.
Rampage Products™ is a trademark of Lund Motion Products, Inc.
Page 2 of 2
Figure 2
Figure 3
Figure 4
The material that your product is made from can
be recycled. Please also consider recycling the
packaging that your product came in.
Publicité
Table des Matières
