Braun 7 Serie Mode D'emploi page 7

All manuals and user guides at all-guides.com
Before shaving
Prior to fi rst use you must connect the shaver to
an electrical outlet using the special cord set
or alternatively proceed as below:
Installing the Clean&Renew station
• Using the special cord set
station power socket
2
• Press the lift button
• Hold the cleaning cartridge
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station
as far as it will go.
• Slowly close the housing by pushing it down
until it locks.
The cleaning fl uid display
fl uid is in the cartridge:
«high» up to 30 cleaning cycles available
«low» up to 7 cleaning cycles remaining
«empty» new cartridge required
Charging and cleaning the shaver
Insert the shaver head down into the cleaning
t
station. (The contacts
shaver will align with the contacts
cleaning station).
If required, the Clean&Renew station will now
charge the shaver. The hygiene status of the
shaver will also be analyzed and one of the
following cleaning program diodes
up:
«clean» shaver is clean
«eco» short economical cleaning required
«normal» normal level of cleaning required
«intensive» high intensive cleaning required
i
i
, connect the
6
to an electrical outlet.
to open the housing.
7
down on a fl at,
1
will show how much
on the back of the
3
in the
5
will light
high high
low low
1 1
empt y empt y
2 2
new new
high high
low low
high high
empty empty
low low
empty empty
high high high high high high
low low low low low low
empty empty empty empty empty empty
high high
low low
empty empty
clean clean
eco eco
normal normal
intensive intensive
auto select auto select
7