Screw,M8 X 50 - Bestop Sunrider Instructions D'installation

Section 4 Attach Sunrider Assembly To Vehicle
Step 1
Turn the Sunrider assembly over then
place it on the vehicle.
Place a Spacer #603.20 between the
Halo Assembly and the vehicle at the
rear mounting position.
Replace the front bolt with the ones that
were removed in section 1 and place a
M8 X 50 Bolt (Part #444.34) and a M8
washer (Part # 515.84) in the rear posi-
tion.
Repeat this step on the left side of the
vehicle.
Tools
T50
Torx Driver
5mm
Allen Wrench
P7 - 52461 Rev. I 0322
Hardware

Screw,M8 X 50

Part #444.34
Qty. 2
M8 Washer
Part #515.84
Qty. 2
Plastic Spacer
Part #603.20
Qty. 2
Installation Instructions - Sunrider for Hardtop
Step 1
Page 7
© 2021 Bestop, Inc.