Panasonic PT-L735NTU Mode D'emploi page 27

NOTE:
B You can also turn off the power by pressing the POWER button twice or
by holding down it for at least 0.5 seconds.
B When the projector is in standby mode (the power indicator on the
projector is illuminated red), the projector will still draw a maximum 7 W of
power, even when the cooling fan has stopped.
(PT-L735NTU only)
B When the WEB STANDBY is set to "ON", the cooling fan operates and
the power indicator on the projector flashes slowly in red and the
projector draw a maximum 30 W of power. (page 48)
B Do not turn off the power while the SD card is being accessed and "SD
CARD IN USE." is displayed on the screen.
Power indicator
Power indicator status
Illuminated
Red
Flashing
slowly
Flashing
Green
Illuminated
Illuminated
Orange
Flashing
RGB INPUT indicator
RGB INPUT indicator status
Illuminated during
standby mode
Illuminated during
projection
26-E
NGLISH
The projector is in standby mode and image projection
is possible by pressing the POWER button.
WEB STANDBY in the NETWORK menu is set to
"ON". The projector can be controlled with personal
computers by means of a wireless network.
(The cooling fan is operating.) : PT-L735NTU only.
The projector is preparing for projection after the
power is turned on while the power indicator is
illuminated red. (After a short period, a picture will be
projected.)
A picture is being projected.
The lamp is cooling down after the power is turned
off. (The cooling fan is operating.)
The projector is preparing for projection after the
power is turned on while the power indicator is
illuminated orange. (After a short period, a picture
will be projected.)
A signal is being input to either the RGB1 IN or
RGB2 IN connector.
A signal is being input to the connector selected
using the input select buttons.
Projector status
Projector status