Connections; Example Of Connecting To Video Equipments - Panasonic PT-L735NTU Mode D'emploi

Connections

Notes on connections
B Read the instruction manual for each system component carefully before connecting it.
B Turn off the power supply for all components before making any connections.
B If the cables necessary for connecting a component to the system are not included with the component
or available as an option, you may need to fashion a cable to suit the component concerned.
B If there is a lot of jitter in the video signal which is input from the video source, the picture on the
screen may flicker. In such cases, it will be necessary to connect a TBC (time base corrector).
B Refer to the list on page 62 for details on compatible signals which can be input to the projector.
B Only one audio system circuit is available for each of the AUDIO IN L-R jacks for
S-VIDEO/VIDEO signals and the RGB AUDIO IN jack, so if you wish to change
the audio input source, you will need to remove and insert the appropriate plugs.

Example of connecting to video equipments

Computer for
control use
Audio system
NOTE:
B If the video signal source is connected using a cable with a BNC connector plug, use a
BNC/RCA adapter (sold separately) to convert the cable end to an RCA plug-type jack.
B If the signal cables are disconnected or if the power supply for the
computer or video deck is turned off while the digital zoom function is
being used, this function will be cancelled.
20E
NGLISH
D-sub 15 (male) - BNC5 (male)
adapter cable
D-sub 9-pin
(male)
Red (connect to P
Blue (connect to P
Green (connect to Y signal connector)
DVD player
signal connector)
R
signal connector)
B
DVD player
Video deck